APGenco and APTransco Previous questions

1. The ratio of voltage and electric current in a closed circuit
   (a) remains constant (b) varies (c) increases (d) falls
2. The resistance of a wire varies inversely as
   (a) area of cross section (b) length (c) resistivity (d) temperature
3. The electrical conductivity of metals is typically of the order of ( in ohm-1 m-1)
   (a) 10 to the power of 7 (b) 10 to the power of 5 (c) 10 to the power of -4 (d) 10 to the power of -6
4. Four resistors, each of resistance R ohms are available. The minimum resistance of the combination will be
   (a) 4R (b) R (c) R/4 (d) R/8
5. The elements which are not capable of delivering energy by its own are known as
   (a) unilateral elements (b) non-linear elements (c) passive elements (d) active elements
6. The magentic susceptibility of paramagnetic material is
   (a) less than zero (b) less than one but positive (c) greater than one (d) equal to zero
7. The Direction of current in an ac circuit
   (a) is from positive to negative (b) is always in one direction (c) varies from instant to instant (d)Cannot be determined
8. which of the following statements associated with purely resistive circuits is correct?
   (a) PF is unity (b) Power consumed is zero (c) Heat produced is zero (d) PF is zero
9. The magnetic field energy in an inductor changes from maximum value to minimum value in in 5m sec when connected to an ac source. The frequency of the source is
   (a) 20 Hz (b) 50 Hz (c) 200 Hz (d) 500 Hz
10. 
    

Control Systems:

1. Electronic control systems have the serious draw-backs of
   (a) low reliability (b) operational difficulty (c) temperature sensitiveness (d) all of above
2. The system whose characteristic equation has the following roots is marginally stable
   (a) -j, j, -1,1 (b) -3,-2,0 (c) -2+3j, -2-3j, -2 (d) -3,-2,-1
3. A phase log compensation will
   (a) improve relative stability
   (b)increase the speed of response
   (c)increase band-width
   (d) increase overshoot
4. For Nyquist plot we use

1. open loop function
2. closed loop function
3. characteristic equation
4. any of the above

1. highly stable
2. oscillatory
3. relatively stable
4. none of these

1. frequency response of a system
2. poles of the transfer function for a set of parameter values
3. bandwidth of system
4. all of the above

1. more stable
2. unstable
3. none of above

1. the output for a given input
2. the type of system
3. the input for a given output
4. the steady state gain

1. error voltage
2. driving voltage
3. opposing voltage
4. none of these

1. decays slowly
2. decays rapidly
3. rises slowly
4. rises quickly

Measurements and Instrumentation

1. Which of the following types of instrument is an integrating instrument?

1. power factor meter
2. energy meter
3. wattmeter
4. frequent meter

1. Constantan
2. Manganin
3. Eureka
4. Nichrome

1. Multipliers
2. Shunts
3. Control Springs
4. Potential transformers

1. Moving Coil Voltmeter
2. Hot wire voltmeter
3. Electro Dynamo meter
4. Electrostatic Voltmeter

1. Low series resistance
2. high resistance in parallel
3. CT
4. PT

1. magnetic voltmeter
2. inductive voltmeter
3. potential transformers with voltmeters
4. current transformers and voltmeters

1. voltmeter
2. wattmeter
3. energy meter
4. ammeter